1. Only front mounted motors are allowed on mowers. no rear mounted motors allowed.

2. Must be a factory lawn mower engine, Briggs & Stratton, Tecumseh, Onan, etc. 

3. Nothing more than 22 horsepower. 

4. No zero turn mowers allowed.

5. Only belt driven mowers allowed.

6. Electric start mower preferred, you must be able to start your mower from your seat. No lying across the hood of your mower to start it.

7. Battery and fuel tank cannot be in front of the motor. They both must be securely attached. Gas tanks must have a cap. Any mower leaking fuel or that is not safe will be disqualified for that heat.

8. All plastic and lights must be removed. Mower decks must be removed.

9. All mowers must have a factory hood and factory fenders. Plastic hoods may be replaced with metal hoods. Hoods must be secured by bolting or chaining shut.

10. All mowers must have leg and foot guards installed. These guards must be built to protect feet and legs. The outside of guards must be covered with sheet metal. they may be welded or bolted to rear fenders and front frame and foot rest area. These guards must be built safe. Any mower with an unsafe leg guard or any guard that falls off during the event will be disqualified or not allowed to participate.

11. A back seat bar is allowed. This is to protect the back of the seat. This bar may be mounted to the rear fenders of the mower.

12. Clean up your welds! We do not want any participants cut from nasty welds.

13. Frames must be stock. Frames may have repair welds. Frames may have added metal to attach bumpers.

14. Exhaust must not extend out from mower hood area. No stacks! Always remember safety first and we don’t want anyone burnt.

15. All mowers must use lawn mower type wheels. rear wheels (rims) may not be any larger than 12 inches in diameter. Tractor treads and cut tires, atv tires are permitted. Air in tires only (no foam filled tires).

16. No dual wheels allowed. no wheel covers. 

17. Tubes are allowed. No slime, or foam filled tires allowed. You are allowed to glue tires to rims.

18. Modifications or replacement of the drive pulleys is allowed, but all mowers must be safe and participate at a safe speed. Official decision is final.

19. Transaxles must be factory available transaxles, but reinforcing and/or welding of spider gears is allowed.

20. Bumpers, all bumpers front and rear must be safe! No pointed or jagged bumpers. Bumpers may not exceed 2” X 2” X ⅛” 

21. No grill guards on front of mower. 

22. No kickers or braces from front bumper to leg guards.

23. All steering must remain stock. 

24. All mowers must have number painted on side or back

26. All drivers must wear a helmet, long sleeve shirt, pants, and boots. STRICTLY ENFORCED! 

27. Mowers must have a roll over bar seat switch and no sharp edges and no exposed exhaust.

Contact Total Chaos Motorsports Via Facebook Messenger With Any Questions!

Have a question, comment, or suggestion? We'd love to hear from you! Get in touch with us using the contact form on our website, and we'll get back to you as soon as possible. You can reach us Total Chaos Motorsports Facebook Messenger, if no response within 12 hours please text Tom at 814-221-5339 and allow 24 hours for response.